1、 Overview of this device:

This machine is specifically designed to test the damage caused by falling products after packaging, and to evaluate the impact resistance of electronic components during transportation. This machine adopts electrical control, and the test material can fall freely in an instant. The diamond, corner, and surface of the packaging container can be tested.

2、 Design applicable standards:

Complies with standards GB/T2423.10-95, IEC68-2-6, ISO2248, JISZO.202-87

3、 Principle editor:

Lift the test sample to the predetermined height, then let it fall freely in the predetermined state and collide with the impact table.

4、 Main technical parameters:

1. Drop height mm: 300-2000 adjustable

2. The maximum weight of the specimen kg: 0-80Kg;

3. Bottom plate thickness: 10mm

4. Maximum size of specimen mm: 800 x 800 x 1500

5. Impact panel size mm: 2000 x 1500

6. Drop height error: ± 10mm

7. Test bench dimensions in mm: approximately 2000 x 1500 x 2700

8. Net weight kg: approximately 580kg;

9. Test method: drop from all directions of face, angle, and edge

10. Control method: Electric

11. Falling height error: 1%

12. Parallel error of the striking panel: ≤ 1 degree

13. Error in angle between the falling surface and the horizontal during the falling process: ≤ 1 degree

14. Power supply: AC220V 50HZ

15. Power: 1.85KWA

5、 Machine studio environment requirements:

Temperature: 5 ℃~28 ℃ [1] (average temperature within 24 hours ≤ 28 ℃)

Relative humidity: ≤ 85% RH

Power supply conditions: three-phase four wire protective ground wire,

Voltage range: AC (380 ± 38) V

Require users to configure corresponding capacity air or power switches for the equipment at the installation site, and this switch must be independent for use by the equipment

6： Equipment features:

1. This machine can perform free drop tests on the surface, corners, and edges of packaging.

2. Equipped with a digital height display instrument and using an encoder for height tracking, it can accurately provide a product drop height with an error of no more than 2% or 10mm from the preset height.

3. This machine adopts a single arm double column structure, with electric reset, electric drop, and electric lifting devices, making it easy to use.

4. Single arm setup allows for easy placement of products, with a drop angle impact surface and floor plane angle error of less than or equal to 5 degrees. The thickness of the bottom plate is 10mm, and the bottom plate has sufficient weight and force area to withstand a load of 80kg at a height of 1.5 meters. During equipment testing, the arm is tilted and does not shake to achieve free drop of the packaging.

5. The motor adopts Taiwan Changyi Motor, and the reset adopts Taiwan Dongli Motor, Shanghai Samson Electromagnetic Valve, Japan Omron Relay, Beijing Shirinda Encoder, and Chint AC Contactor.